Pentair screenlogic interface protocol adapter red light lasopaceleb

Screenlogic Interface Protocol Adapter. Pentair ScreenLogic Interface and Wireless Connection Kit 522104 • Connect the power cord to a wall outlet or surge protector and then plug it into the back of the Interface Protocol Adapter. ScreenLogic2 PC ITC15 Interface Kit Part # 520500 Protocol Interface Adapter Kit Includes cable and Instructions Does not include antenna package part # 523434 (can be purchased separately) Complete ScreenLogic2 can be purchased Part # 522104 Interface Kit may arrive in original ScreenLogic2 Box

For PCs, download the ScreenLogic setup program for Windows XP, Windows. Once the Protocol Adapter is up to date, perform the subsequent updates depending on the interfaces you have installed in your system.

Pentair 520501 ScreenLogic Interface Kit iTC25 Includes

Once the Protocol Adapter is up to date, perform the subsequent updates depending on the interfaces you have installed in your system. Once the Protocol Adapter is up to date, perform the subsequent updates depending on the interfaces you have installed in your system. NOTE: The above ScreenLogic Interface Kits (520500 and 520502) require a 4-wire, 22 guage wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter within the home

PENTAIR Screenlogic Interface Wireless Connection Kit Manual ItsManual. For PCs, download the ScreenLogic setup program for Windows XP, Windows. ScreenLogic Connect interface software for PC and Mac

Connect to the Protocol Adapter Pentair Intellitouch ScreenLogic. Plug the AC power adapter into an AC wall-outlet and into the wireless transceiver unit to power up the unit (see page 8) ID number (Outdoor transceiver) IMPORTANT NOTICE: Be sure the yellow ID label (9-digit ID number